Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 03:38 29 Mar 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : Head scratcher

Author Message
SimpleSafeName

Senior Member

Joined: 28/07/2019
Location: United States
Posts: 284
Posted: 04:00am 25 Sep 2019
Copy link to clipboard 
Print this post

Hi guys,

So I've got a BTR (Between Tape & Reader) board that has failed and I am painstakingly recreating it in Kicad to get a schematic.

During the process of documenting it, I came across two caps, one electrolytic, the other tantalum. They are both 10 uF, and they are both connected in parallel.

It seems odd that two of the same size but different technologies to be connected in parallel.

Has anyone else seen this? I know it works, but it seems odd.


Thanks,

John
 
Boppa
Guru

Joined: 08/11/2016
Location: Australia
Posts: 814
Posted: 04:33pm 25 Sep 2019
Copy link to clipboard 
Print this post

Sure it's a tag?- paralleled electrolytic's and film/polyprop caps is quite common- electros for smoothing the DC mains ripple (low frequency, larger energy transfers) and films for stopping high frequency stuff where electro's don't work well (bleedthrough from RF transmiters)

Was common in RF stuff to see that combo, not tags tho
Edited 2019-09-26 02:36 by Boppa
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024