Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 23:49 19 Apr 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : using  a MPPT solar control on a wind turbine?

Author Message
rgormley
Senior Member

Joined: 22/02/2006
Location: Australia
Posts: 245
Posted: 02:30am 07 Jun 2020
Copy link to clipboard 
Print this post

I have a MPPT EP solar 4210RN feeding my 24V bank from 500W of solar
all happy and working
specs: 100V DC input 1000W at 24V (40AMP)


QUESTION: i have bought a 48v 500w 6 blade aliexpress cheap 500watt wind turbine.
Can i run the DC output (after the 3 phase bridge rectifier) into the solar charge controller (4210RN) effectively in parallel with the solar panel input)via the wind turbines 3 phase bridge DC out

or should i keep the turbine separated and just feed it straight to the batt bank?

** oh and i will have a over voltage sense cct that activates a dump load on the ac side of the turbine if the volts get up to 28~29v on the bat bank (has time based hysteresis to stop rapid cycling)

Thanks
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024