Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 09:20 29 Mar 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : Winding Transformers

     Page 5 of 5    
Author Message
Alston
Regular Member

Joined: 04/04/2021
Location: Australia
Posts: 62
Posted: 07:48am 22 May 2022
Copy link to clipboard 
Print this post

I just meant winding a series of turns around the core and then doing the calculation before I unwound the cores to make my bigger one.
 
Alston
Regular Member

Joined: 04/04/2021
Location: Australia
Posts: 62
Posted: 08:48am 23 May 2022
Copy link to clipboard 
Print this post

Primary done. I wound this from one layer of 1.8mm and one layer of 1.3mm. The groves in the end caps meant this still allowed me to end up with a flat first layer.





 
Alston
Regular Member

Joined: 04/04/2021
Location: Australia
Posts: 62
Posted: 01:12pm 18 Jul 2022
Copy link to clipboard 
Print this post

Here is the transformer line up. I still need to add the primary to the big transformer and I am going to redo the smallest transformer as I wasn't happy with how it turned out (it was the first one I did).


 
     Page 5 of 5    
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024