 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Electronics : Newbie needs elec help - repost
| Author | Message | ||||
Gizmo Admin Group  Joined: 05/06/2004 Location: AustraliaPosts: 5030 |
moonfish wrote..... Hi guys, my name is shannon and im a newbie to building wind turbines. I have a f&P stator and rotor setup in my workshop that is giving me upwards of 300vdc, how do i regulate this for a charge controller/battery bank? GWatPE wrote..... There is a wealth of info in the articles section and in the many postings in threads in the windmills thread on this forum. You would be advised to perform some simple searches to narrow down what you are looking for. PS: Gizmo has pointed out the dangers of testing unmodified F&P PM motors at modest speeds, so take extreme care with the high voltage AC produced at the terminals. Gordon. CraziestOzzy wrote..... One turn of of an unmodified F&P is rather nasty...don't go sticking the phase leads in your mouth to see if you can feel anything 
The best time to plant a tree was twenty years ago, the second best time is right now. JAQ |
||||
 Print this page |
