Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 07:26 20 May 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : New type Stator from F&P

Author Message
brucedownunder2
Guru

Joined: 14/09/2005
Location: Australia
Posts: 1548
Posted: 02:31am 17 Jan 2007
Copy link to clipboard 
Print this post

I see a few guys have bought the new F&P Rotor and are trying this on re-configured 7 phase wiring.

Any one ,apart from me bought a newstyle STATOR and re-configured it like the old original stators into 3 phase ??.

Mine is up and running but fairly poor o/p,just 50 or so watts(3Phase /4pole .6mm wire)Could be the low winds we are getting.

Matt, got a bit confused about the way u might have tested your unit--but I do remember with one of the combinations of mixing the new and old Rotors with different stators(new and Old) there was a complete mismatch and just nothing ,not even any cogging.

Bruce
Bushboy
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024