Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 03:05 04 May 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : 7P1P Welder

Author Message
nweeks

Newbie

Joined: 22/01/2007
Location: Australia
Posts: 36
Posted: 06:16am 23 Jan 2007
Copy link to clipboard 
Print this post

Just wondering if anyone's measured how much grunt(current) can actually be drawn from an F&P motor?

Would the 7 phase 1 pole arrangement deliver over 80A?
Actually, I'd put six phases into bridge recs, and the last phase into a 12/240 step up, with two diodes for arc starting...

Anyone done this?

Nige.
Nigel Weeks
nweeks at karbonit dot com
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025