 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Electronics : F & P Smart Drive motor
| Author | Message | ||||
| bill_gill85 Newbie  Joined: 22/05/2007 Location: Posts: 3 |
Hi, I am placing an entry into an electric vehicle challenge & was wondering about the suitability of using a F&P motor as a hub motor (driven as a 36V stepper motor). Has anyone tried this & is it suitable? |
||||
Gizmo Admin Group  Joined: 05/06/2004 Location: AustraliaPosts: 5031 |
Yes I have tried it. See http://www.thebackshed.com/mackaysolarcar/index.html We gave up on the idea after several month trying. Problems with the mosfets blowing. The mosfets work in a 3 phase H bridge configuration, the high side driver is a fiddly beast. But I think it could be done, we just ran out of time. Glenn  The best time to plant a tree was twenty years ago, the second best time is right now. JAQ |
||||
| dwyer Guru  Joined: 19/09/2005 Location: AustraliaPosts: 573 |
Hi gimzo Do you have any Schematic drawing for using a F&P motor specility low voltage 12 to 36 ?? Thank  Dwyer |
||||
 Print this page |
