Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 05:11 16 Jul 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : rectifier connection to F&P

Author Message
Rubes
Newbie

Joined: 01/05/2009
Location:
Posts: 36
Posted: 08:11pm 10 Dec 2015
Copy link to clipboard 
Print this post

Hi Guys
I am sure this would have been covered somewhere but have searched in vain. Basically I need to know which of AC1, AC2 and AC3 of rectifier goes to which of the 3 wires from the rewired Fisher and Paykel genny.



Thanks in advance
 
Gizmo

Admin Group

Joined: 05/06/2004
Location: Australia
Posts: 5117
Posted: 10:47pm 10 Dec 2015
Copy link to clipboard 
Print this post

Hi Rubes

Doesn't matter, its 3 phase AC, and because we are converting it to DC, it does not matter which way you connect the 3 wires up. If you were wiring up a 3 phase motor, it would then be important, as the motor could run backwards if you get it wrong.

Glenn
The best time to plant a tree was twenty years ago, the second best time is right now.
JAQ
 
Rubes
Newbie

Joined: 01/05/2009
Location:
Posts: 36
Posted: 01:07pm 11 Dec 2015
Copy link to clipboard 
Print this post

Thanks Gizmo
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025