TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 06:53 04 May 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : For Sale : Wind Turbine- 500W+

Author

Message

KarlJ

Guru

Joined: 19/05/2008
Location: Australia
Posts: 1178

Posted: 11:44am 10 Nov 2009

Copy link to clipboard

Print this post

The bug has bitten so I'm going for a dual stator, hence this one has to go as I've only got one tower.

A randys workshop "weldment", modified to include a stop to avoid blades hitting the tail.

Addition of the Yeasu thrust bearing and tail.

Set of blades PVC, 1200mm (giving diameter of about 2.5M).

Foundry and fiberglass nose cone and aluminium prop hub with splines.
80 series stator rewired for your chosen voltage.

Would certainly out perform a 500W chinese mill at over $1000 from Jaycar and would run quieter and not require the "cheap chinese mill mods" as described on this forum.

Asking $600 which is less than what it owes me.

Luck favours the well prepared

VK4AYQ
Guru

Joined: 02/12/2009
Location: Australia
Posts: 2539

Posted: 11:39am 05 Dec 2009

Copy link to clipboard

Print this post

Hi Karl
how much would it cost to send to 4311

All the best

Bob

Foolin Around

KarlJ

Guru

Joined: 19/05/2008
Location: Australia
Posts: 1178

Posted: 12:37am 06 Dec 2009

Copy link to clipboard

Print this post

freight is $140 including insurance.

As we're paying dimensional here- If you wanted a couple of extra motor sets, the freight on them would be free and I'd give you the two spare motors / shafts bearings for free.

Karl

Luck favours the well prepared

Print this page

To reply to this topic, you need to log in.