Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 20:42 29 Apr 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Wanted : Wanted: low power turbine

Author Message
GlennP

Newbie

Joined: 29/01/2009
Location: Australia
Posts: 2
Posted: 10:06am 29 Jan 2009
Copy link to clipboard 
Print this post

I'm looking for a turbine, built and ready to go (used commercial or home grown fine). It need be no more than 100 watts or so. I don't want anything too big. For small alternative power setup on a shack we have down the coast.

If you have one to get rid of and it's in reasonable condition, please post.
Glenn
www.evans-pure.net
 
robbo

Regular Member

Joined: 25/03/2007
Location: Australia
Posts: 71
Posted: 02:39am 04 Apr 2009
Copy link to clipboard 
Print this post

Hey Glenn,
What do you mean by "down the Coast" I am in Brisbane, and down the coast means Gold Coast. I can travel to top end of NSW coast if that helps!
Have you seen my post (Garage sale). Plenty of things to buy.
???

http://www.thebackshed.com/windmill/forum1/forum_posts.asp?T ID=1656&PN=1

Edited by robbo 2009-04-05
"the Earth was not given to us, by our fathers, rather, it is lent to us by our children".
 
GlennP

Newbie

Joined: 29/01/2009
Location: Australia
Posts: 2
Posted: 04:42pm 04 Apr 2009
Copy link to clipboard 
Print this post

Sorry, should have been clearer. Down the coast is the south coast of NSW (Eden).

Cheers
Glenn
Glenn
www.evans-pure.net
 
Smart Drives

Senior Member

Joined: 06/07/2009
Location: Australia
Posts: 115
Posted: 04:01am 17 Jul 2009
Copy link to clipboard 
Print this post

Hi Glen, I have an old 300 watt 12 volt
turbine it still works fine . i Can show you how
to reduce its power.

email me at smartdrivesaustralia@gmail.com

Thanks.

Cameron.

All smart drive parts sold
Custom built turbine parts on
Multicam flatbed CNC Router
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024