TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 18:52 13 Nov 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Question - Can the MM output to multiple touch screens?

Page 2 of 2

Author

Message

AussieWombat
Newbie

Joined: 04/05/2018
Location: Australia
Posts: 21

Posted: 07:25am 13 Mar 2020

Copy link to clipboard

Print this post

Hi All,

Thanks for the info.

I think what I will try and do, is have an MM controlling two screens Back to Back, so the cable would be short. Would it still work on the 7 inch screens? Could I use the SDcard slot on the screens to load images?

The idea is they will be able to be viewed from 2 directions, and display the same image/info. They would be placed out of reach of most people, so touch would not be required. ( They are Checkout lights in the supermarket )

Maybe another MM could act as the master on a 1 wire system( short string commands sent ), and the the display screens could be the slave. This MM may master two slave MM. One for each checkout.

Command 1 would display a set feature, and further command's would set or display other features. This would be placed near the operator, and would use the touch interface.

Thanks again for all the comments.

Regards
AussieWombat

PeterB
Guru

Joined: 05/02/2015
Location: Australia
Posts: 655

Posted: 07:48am 13 Mar 2020

Copy link to clipboard

Print this post

I suspect you and Grogster are on the same page with back to back displays.

Peter

Page 2 of 2

Print this page

To reply to this topic, you need to log in.