Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 05:25 21 Nov 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Bit of a TEMPR() tantrum...

     Page 2 of 2    
Author Message
Tinine
Guru

Joined: 30/03/2016
Location: United Kingdom
Posts: 1646
Posted: 07:08pm 08 Jun 2022
Copy link to clipboard 
Print this post

Oh, I'm not concerned because they are easily filtered.

Anything above 30 degrees is error-less.

I sat on one (yes, it was horizontal ) and this is probably TMI but my buttski was a minimum of 34 degrees    






Craig
 
lizby
Guru

Joined: 17/05/2016
Location: United States
Posts: 3481
Posted: 08:29pm 08 Jun 2022
Copy link to clipboard 
Print this post

  Tinine said  Do you get "1000" (bad reading) at the lower temperatures?


I get 1000 for device not connected. I sometimes get 85 for misconnected. For below zero, I get appropriate values--as low as -12C when converted for negative (I don't remember how, and it's not with MMBasic).
PicoMite, Armmite F4, SensorKits, MMBasic Hardware, Games, etc. on fruitoftheshed
 
Tinine
Guru

Joined: 30/03/2016
Location: United Kingdom
Posts: 1646
Posted: 04:55am 09 Jun 2022
Copy link to clipboard 
Print this post

  lizby said  
I get 1000 for device not connected.


Hmmm, I have this thing on the same flaky breadboard as my other stuff...OK, it's getting soldered    
 
     Page 2 of 2    
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025