 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : no internet
  Page 2 of 2 |
|||||
| Author | Message | ||||
palcal Guru  Joined: 12/10/2011 Location: AustraliaPosts: 1993 |
GFX Term working OK @ Robert.Rozee...is there an 80/43 version having ore lines is a big help. "It is better to be ignorant and ask a stupid question than to be plain Stupid and not ask at all" |
||||
TassyJim Guru Joined: 07/08/2011 Location: AustraliaPosts: 6283 |
No problems with any USB-serial adapters on my Windows 11. (Apart form the usual Prolific driver issues). I would think that "legacy device" refers to the on-board serial ports, not USB. What port number did you end up with? Jim VK7JH MMedit |
||||
| palcal Guru Joined: 12/10/2011 Location: AustraliaPosts: 1993 |
Port # 3 When I first looked in Device Manager there was no Ports(COM and LPT) listed I had to add them. "It is better to be ignorant and ask a stupid question than to be plain Stupid and not ask at all" |
||||
| TassyJim Guru Joined: 07/08/2011 Location: AustraliaPosts: 6283 |
It will be interesting to see if ports #5 and above can be enumerated without intervention. Jim VK7JH MMedit |
||||
| Page 2 of 2 |
|||||
 Print this page |
 |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2025 |
