 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : PI*Bert Game engine ?
  Page 2 of 2 |
|||||
| Author | Message | ||||
IanRogers Senior Member  Joined: 09/12/2022 Location: United KingdomPosts: 152 |
This is a bit crazy. I'm not up to speed properly yet But I run this on my picomiteVGA 5.7.8b17 and it just stops.. I get a cursor in mode 2 flashing without error. >_ At first it said bad syntax autosave after deleting it runs to that command prompt. If I open editor its flashing at the line FRAMEBUFFER Layer ' create buffer for actor overlay Do I need to enable sprites? Edited 2023-09-19 19:41 by IanRogers I'd give my left arm to be ambidextrous |
||||
| IanRogers Senior Member Joined: 09/12/2022 Location: United KingdomPosts: 152 |
Never mind... FRAMEBUFFER layer.. LOL in the manual 252000 only. Works fine now. Cheers anyway. I'd give my left arm to be ambidextrous |
||||
vegipete Guru  Joined: 29/01/2013 Location: CanadaPosts: 1153 |
Here's another copy of a short program to display the game sprites. I've changed the sprite order to perhaps make coding easier, and added *Bert's curse bubble. Needs a late ver5.07.08 beta or release candidate firmware. Could someone (Lizby?) post a screen shot? Thanks. Visit Vegipete's *Mite Library for cool programs. |
||||
| lizby Guru Joined: 17/05/2016 Location: United StatesPosts: 3514 |
 PicoMite, Armmite F4, SensorKits, MMBasic Hardware, Games, etc. on fruitoftheshed |
||||
| Page 2 of 2 |
|||||
 Print this page |
 |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2025 |
