 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Electronics : Build a Multi Phase PV Charger and 230Vac Inverter Using Pi Pico
  Page 2 of 2 |
|||||
| Author | Message | ||||
| Solar Mike Guru  Joined: 08/02/2015 Location: New ZealandPosts: 1247 |
While waiting for these pcb's to arrive, have been busy doing some work on an Inverter, that design is for a 100v system, however it is designed such that two H-Bridge boards can be paralleled to the same transformer primary, thus doubling the output without having to build one with bigger busbars when running on a lower voltage 48v setup. All future posts on the inverter will be on the other thread. Expect these pcb's to be back here on Monday, will start working on them, as they need installation in the next couple of weeks. Cheers Mike |
||||
| Page 2 of 2 |
|||||
 Print this page |
 |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2026 |
