Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 23:14 09 May 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : MM2: Tuning the clock

     Page 2 of 2    
Author Message
Zonker

Guru

Joined: 18/08/2012
Location: United States
Posts: 767
Posted: 11:56am 20 Sep 2016
Copy link to clipboard 
Print this post

Awesome Peter..!

Perfect timing... I wanted to use the timer count as an engine hours meter for the RTC gauge... I put in a MB85RS64 Fram IC on the Rev-B interface PCB to store the timer val as well as service counters, engine start/stops, ect... Without your CAL procedure, setting this up would take way longer..!

BTW, I now have the Rev-B Gauge engine PCB in and test built the first... Works like a champ.. So, I was wondering if you are still wanting another one to play with..? Would be no problem on this end... Will send a built up interface PCB as well...
 
     Page 2 of 2    
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025