Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 17:44 02 Aug 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : I2C Support needed

     Page 3 of 3    
Author Message
PeterB
Guru

Joined: 05/02/2015
Location: Australia
Posts: 655
Posted: 07:51am 29 Sep 2021
Copy link to clipboard 
Print this post

G'Day Mick.

I didn't write it, I think it just "growed", but I wish I was that neat and clever.

My only effort was many years ago when I generated code to send START ONE ZERO ACK, was there an END? I can't remember but it was for a Z80 or 16F84. I can't remember what I was shouting at but it must have been very tolerant.  

The ARDUINO does make it very easy not so the MM.

Peter
 
     Page 3 of 3    
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025