 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : Armmite F4 LCD interface PCB
  Page 3 of 3 |
|||||
| Author | Message | ||||
Mixtel90 Guru  Joined: 05/10/2019 Location: United KingdomPosts: 7499 |
It wouldn't be the first time I'd got connector hole sizes wrong. :( I'm not sure if you'll get them to fit - the hole size used is 0.72mm. I've checked and I'd enlarged it to 1mm on the SSD1963 prototypes. I'll correct it in the Gerber files. Unfortunately drilling them out probably isn't an option on double sided an multi-layer boards. I keep getting tripped up by this because SL6 defaults to 0.72mm for headers. That's fine for female headers but not for many male ones. You'd think I'd learn. :( EDIT: REVISED GERBERS - THESE REPLACE THE ORIGINAL ISSUE Hydra 40-80.zip This is now a Revision A board. Since the prototype I'd re-done it to make it double sided rather than multi-layer. It may be slightly cheaper now. I've just increased the connector hole diameters for all male headers. Edited 2023-11-04 05:51 by Mixtel90 Mick Zilog Inside! nascom.info for Nascom & Gemini Preliminary MMBasic docs & my PCB designs |
||||
| Page 3 of 3 |
|||||
 Print this page |
 |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2025 |
