TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 07:11 19 Dec 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Simple

Page 3 of 3

Author

Message

matherp
Guru

Joined: 11/12/2012
Location: United Kingdom
Posts: 10715

Posted: 08:10am 12 Dec 2025

Copy link to clipboard

Print this post

There is a bezier command in the code as well, but for some reason it isn't enabled. I'll include it in the final release.

Quote BEZIER x%(),y%() [,n] [,colour]
Draws a Bezier curve with an unlimited number of control points. ‘x%()’ and ‘y%()’ are single dimension integer arrays holding the coordinates of the control points.
The Bezier curve always starts at the first control point. The arrays must have the same dimensionality.
The optional parameter ‘n’ defines how many control points to use for the plot. If omitted the size of ‘x%()’ and ‘y%()’ determine the number. N must be >=2 and <= the array size.
The optional parameter ‘colour’ defines the colour to plot the curve (defaults to white)

Edited 2025-12-12 18:23 by matherp

Martin H.

Guru

Joined: 04/06/2022
Location: Germany
Posts: 1331

Posted: 08:36am 12 Dec 2025

Copy link to clipboard

Print this post

Good Morning Peter,
That sounds very promising and gives you more scope to read or generate vector-based images.
Thanks a lot
Martin

'no comment

Page 3 of 3

Print this page

To reply to this topic, you need to log in.