Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 06:52 02 Aug 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Picomite Terminal session from a Raspberry Pi

Author Message
Rickard5

Guru

Joined: 31/03/2022
Location: United States
Posts: 463
Posted: 05:24am 08 Aug 2022
Copy link to clipboard 
Print this post

I've been fighting this all day and I can't figure it out I'm trying to connect to a Picomite Via USB from a Pi 400 as User Pi following this thead  from the instructions document. I've installed Minicom and can't seem to get it working. can anyone please help?  my ultimate goal is to be able to VPN in to a Pi 3B from my iPad, and open up a session to a Picomite to work on picomite stuff in my barcalounger
I may be Vulgar, but , while I'm poor, I'm Industrious, Honest,  and trustworthy! I Know my Place
 
TassyJim

Guru

Joined: 07/08/2011
Location: Australia
Posts: 6283
Posted: 06:52am 08 Aug 2022
Copy link to clipboard 
Print this post

If you want to do remote access, I suggest you look at ser2net.
I run most of my in service micromites hanging of RPis and using ser2net.

Jim
VK7JH
MMedit
 
JohnS
Guru

Joined: 18/11/2011
Location: United Kingdom
Posts: 4044
Posted: 09:29am 08 Aug 2022
Copy link to clipboard 
Print this post

  Rickard5 said  I've been fighting this all day and I can't figure it out I'm trying to connect to a Picomite Via USB from a Pi 400 as User Pi following this thead  from the instructions document. I've installed Minicom and can't seem to get it working. can anyone please help?  my ultimate goal is to be able to VPN in to a Pi 3B from my iPad, and open up a session to a Picomite to work on picomite stuff in my barcalounger

I think you'd have to say step by step what you did and at what point it failed with what messages.

John
 
scruss
Regular Member

Joined: 20/09/2021
Location: Canada
Posts: 91
Posted: 02:03am 10 Aug 2022
Copy link to clipboard 
Print this post

  Rickard5 said  ... can't seem to get it working.


What have you tried? We're not psychic
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025