Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 06:50 02 Aug 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : cfgen to teraterm transfer

Author Message
crez

Senior Member

Joined: 24/10/2012
Location: Australia
Posts: 152
Posted: 06:42pm 02 Nov 2017
Copy link to clipboard 
Print this post

Are there some 'magic' settings which allow copying and pasting from the output of cfgen to the micromite edit window under teraterm? I'm getting extra spaces at the beginning of lines that cause 'line too long' errors, and then it all goes haywire.

David
 
TassyJim

Guru

Joined: 07/08/2011
Location: Australia
Posts: 6283
Posted: 08:03pm 02 Nov 2017
Copy link to clipboard 
Print this post

I think you need to remove any leading white space before pasting into teraterm.

Easily done in MMEdit and Notepad++

Jim
VK7JH
MMedit
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025