Hi,

anybody use this card from Olimex ESP32-SBC-FabGL .

I try to run PCEmulator on it , but SDCARD not found and GPIO for the SDCARD is not the same than lillygo TTGO esp32 VGA .

on youtube everybody run successfully PCEmulator on this card !

PCEmulator is based on FabGL (fork for Olimes)



@+

Alfa

Hi.

   From the circuit diagram for the Olimex module:

CS         GPIO 13
MOSI       GPIO 12
CLK        GPIO 14
MISO       GPIO 35

Hope this helps.

Link to the circuit digram,

https://github.com/OLIMEX/ESP32-SBC-FabGL/blob/main/HARDWARE/Hardware-revision-B/ESP32-SBC-FabGL_Rev_B.pdf

Trevor

  TrevorC said  

Hi.

   From the circuit diagram for the Olimex module:

CS         GPIO 13
MOSI       GPIO 12
CLK        GPIO 14
MISO       GPIO 35

Hope this helps.

Link to the circuit digram,

https://github.com/OLIMEX/ESP32-SBC-FabGL/blob/main/HARDWARE/Hardware-revision-B/ESP32-SBC-FabGL_Rev_B.pdf

Trevor

IT WORKS now .. oufti

Ex deus Machina .. hardware is very very subtile ... buy another sdcard (philips 32GB .. and magic FabGL PCemulator found it , format and install from menu Windows .. 3.00

Works nicely  ..


And this without change original code .. run on Olimex ESP32-SBC-FABGL and on TTGO VGA 1.4

the cost of the boards are the same .. +/- 16€

@+
Amiga