Roger thats both hilarious and worrying at the same time. I always suspected toroidal manufacturing was an exacting precision art.

It also makes you wonder if someone woke up and was missing their colourbond fence overnight that had been removed & then cut into narrow strips and repurposed......

The Asians are positively high tech state of the art, compared to what goes on in Africa....


Why even bother with a welding transformer anyway ?
(Do NOT try this at home)
https://www.youtube.com/watch?v=HTJKksnurS0
Edited 2021-04-14 12:55 by Warpspeed

  wiseguy said  

Roger thats both hilarious and worrying at the same time. I always suspected toroidal manufacturing was an exacting precision art.

It also makes you wonder if someone woke up and was missing their colourbond fence overnight that had been removed & then cut into narrow strips and repurposed......

Haha, heah. I noticed one piece had a quarter inch step on one side. Very roughly cut.

I was just as worried about the saw blade. I suppose it was being used as a washer but I reckon I could have found something a little safer.

He did make quite an effort to make it tight so full marks there.

  Warpspeed said  

The Asians are positively high tech state of the art, compared to what goes on in Africa....


Why even bother with a welding transformer anyway ?
(Do NOT try this at home)
https://www.youtube.com/watch?v=HTJKksnurS0

That transformer looks like it belongs out the back of the Ettamogah Pub. Certainly fell off the back of a truck.

I don't think the home welder has a future. Anyone using one probably wont have much of a future either  ...  and those guys, very poor eyesight.