Menu
JAQForum Ver 26.09

Forum Index : Microcontroller and PC projects : Pico Computer 3 - One board to rule them all

   Page 11 of 11    
Posted: 09:14pm
10 Nov 2026
Copy link to clipboard
cdeagle
Senior Member

Is it possible to plug the PicoMite 3 into a PC and use TeraTerm and MM Edit 5?
 
Posted: 09:32pm
10 Nov 2026
Copy link to clipboard
phil99
Guru


It has a built-in serial to USB adapter (U7 - CH340) for the serial console, connected to COM2 on GP8 & 9.
The console USB-C socket (USB2) is near the HDMI socket.
.
Edited 2026-11-11 07:49 by phil99
 
Posted: 09:51pm
10 Nov 2026
Copy link to clipboard
TassyJim
Guru


  cdeagle said  Is it possible to plug the PicoMite 3 into a PC and use TeraTerm and MM Edit 5?


Depending on which firmware you have loaded, MMEdit will connect to the USB "firmware update" port just like a "normal" picomite.
If you load one of the standalone firmwares, you use the serial-USB adapter which is part of the PC3. In this case you have to be sure to use the correct baud rate. Usually 115200

Jim
 
Posted: 10:08pm
10 Nov 2026
Copy link to clipboard
cdeagle
Senior Member

Thanks guys. That worked especially when I turned on the power switch.

Call me old fashioned.
 
Posted: 07:44am
18 Nov 2026
Copy link to clipboard
Volhout
Guru


@Peter,

After some twiddling around with the PC3, in light of the potential official release of the PC3, I would like to suggest some changes to it.

1/ Remove the power button (you have to pull out the USB-C to get to it, and then the unit is already off).
2/ The expansion header sticks out, and may cause others grief, as it did me once (I pushed the unit accidentally against a (metal) isolated coffee mug, causing a reboot. I now have red isolation tape over it (I tried a non-connected female connector, but got in conflict with the HDMI).

I see 4 options
2a/ Move the whole header footprint 3mm inwards, so the pins stay inside the bezel surface of the housing.
2b/ Move the HDMI away from the header, so you can use a boxed (molex) header as with CMM2. This can only be done with the power button removed.
2c/ Use a female header (this makes the unit incompatible with the units built if you design peripherals).
2d/ Mount a 26pin boxed header, not using pins 27..30 (closest to the HDMI). This essentially removes +5V and system I2C from the header.

I think option 2a has least impact.

Regards,

Volhout
Edited 2026-11-18 18:06 by Volhout
 
   Page 11 of 11    


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2026