TheBackShed.com

Home	JAQForum Ver 20.06
Log In or Join
Active Topics
Local Time 16:57 26 Apr 2024	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : teraterm no keyboard response

Page 3 of 3

Author

Message

stanleyella

Guru

Joined: 25/06/2022
Location: United Kingdom
Posts: 1642

Posted: 03:12pm 04 Oct 2022

Copy link to clipboard

Print this post

I just realised that mmcc is a terminal that mmedit uses.
I always closed it to use mmedit again or there are multiple mmcc when I close mmedit.
I opened a blit demo in mmedit and ctrl-c stopped the code with an image still on lcd.
in mmcc open typing run restarted the code.
I clicked the flash button in mmedit and the demo restarted.
I pressed ctrl-c and it did not stop it.
I powered off and disconnected usb and reconnected and clicked flash again to reprogram and ctrl-c stopped the code.
This could just be a key board problem. I will try another usb key board.

I am copying all info posted that I can't find in the manual to a file and a win icon to it. lots of key presses but appreciated info.

I got to go with the flow and follow the rules.

The do loop was used to keep a previous basic not clearing something and it stuck instead of end.
stan

Page 3 of 3

Print this page

To reply to this topic, you need to log in.