Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.
|
Forum Index : Microcontroller and PC projects : User Manual for the Picomite (draft)
Page 5 of 5 | |||||
Author | Message | ||||
LouisG Senior Member Joined: 19/03/2016 Location: AustraliaPosts: 121 |
Hi, This is regarding the block diagram of the Pico's power supply on page 11 of the Picomite manual. The diagram shows the USB DC input and the four terminals for connections by the user but it doesn't explicitly show an output to power the Pico itself. Why not show it? One could assume a couple of ways it connects. But why assume (as the saying goes)? Show it! Could be an arrow labelled TO PICO +3.3V INTERNAL BUS, or similar. Louis - |
||||
Geoffg Guru Joined: 06/06/2011 Location: AustraliaPosts: 3165 |
I'm not sure that it is that important but OK, I will add an arrow for the next release. Geoff Geoff Graham - http://geoffg.net |
||||
Page 5 of 5 |
Print this page |