TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 05:51 19 May 2026	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : 150V 45A MPPT - roll your own

Page 51 of 51

Author

Message

Revlac

Guru

Joined: 31/12/2016
Location: Australia
Posts: 1257

Posted: 12:51am 18 May 2026

Copy link to clipboard

Print this post

While it is doable, the Charge controller has copper plate on top and bottom of the PCB so more unnecessary work leaving the NC legs on, personal preference perhaps.

Cheers Aaron
Off The Grid

nickskethisniks
Guru

Joined: 17/10/2017
Location: Belgium
Posts: 474

Posted: 08:44am 18 May 2026

Copy link to clipboard

Print this post

You could make a daughterboard "capacitor pcb" that fits the original holes. Or a redesign of the pcb, I could do that for the first version if you want. Wiseguy designed the last version that I can't modify. But you might have the boards allready?
It's a robust design made for long life so better do it first time right.

Page 51 of 51

Print this page

To reply to this topic, you need to log in.