 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : GAP2 - just an idea
  Page 2 of 2 |
|||||
| Author | Message | ||||
Mixtel90 Guru  Joined: 05/10/2019 Location: United KingdomPosts: 8753 |
I knew it would be dearer than my usual boards, simply because it's bigger than 100mm square. The shipping isn't subsidised on bigger boards either. I don't know about the engineering fee - I think I've seen that before. I don't think there's anything particularly special about this one. If the WeAct behaves then I think the rest will be ok. I hope the additional components round the KEY pin don't upset its use as MOSI for the SDcard. If it doesn't work we may have to swap the MOSI and CS connections to the WeAct and run the SDcard in bitbang mode = assuming it will. Mick Zilog Inside! nascom.info for Nascom & Gemini Preliminary MMBasic docs & my PCB designs |
||||
| lizby Guru Joined: 17/05/2016 Location: United StatesPosts: 3733 |
The WeAct RP2350 has 16 megabytes for drive A, so an SD card often isn't really needed (though I'm glad Peter's HDMI board had one when I removed the MODFILE option, which wiped drive A (it gives a warning)). I had backed my files to B. PicoMite, Armmite F4, SensorKits, MMBasic Hardware, Games, etc. on FOTS |
||||
| lizby Guru Joined: 17/05/2016 Location: United StatesPosts: 3733 |
GAP2V1 HDMI/DVI in action PicoMite, Armmite F4, SensorKits, MMBasic Hardware, Games, etc. on FOTS |
||||
| Page 2 of 2 |
|||||
 Print this page |
 |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2026 |
